Kuala Lumpur | Selangor | Shah Alam | Klang | Petaling Jaya | Subang Jaya | Cyberjaya | Rawang | Kajang | Bangi | Port Klang | Pulau Indah | Johor Bahru | JB | Pasir Gudang | Pengerang | Kulai | Batu Pahat | Muar | Kluang | Melaka | Bukit Rambai | Sungai Udang | Masjid Tanah | Alor Gajah | Nilai | Seremban | Senawang | Ipoh | Taiping | Penang | George Town | Batu Kawan | Bayan Lepas | Bukit Mertajam | Perai | Kulim | Sungai Petani | Kuantan | Gebeng | Kemaman | Kuala Terengganu | Kota Bharu | Kuching | Bintulu | Miri | Sibu | Kota Kinabalu | Labuan | Brunei
Powder Film Comb | Uncured Powder Gauge | Coating Thickness Comb | Powder Thickness Gauge
Powder coating thickness measurement | Pre-cure film evaluation | Application control | Coating uniformity check | Process quality control
Comb thickness measurement | Powder film notch method | Dry film pre-cure assessment | Mechanical thickness checking
Powder coating | Automotive | Industrial finishing | Manufacturing
Details
Available in four scale ranges, the Elcometer 155 Uncured Powder Film Comb is designed to measure uncured powder coating film thickness.
This enables the application system to be set up and fine tuned prior to the curing process. In turn, this will reduce the amount of scrap and over-spray.
Place the comb into the powder and slide the comb along the surface. The measurement points (or teeth) are pointed and allow the powder to flow around them.
The thickness of the powder lies between the highest value where a drag mark is visible and the lowest value where a drag mark has not been produced.
Note: The thickness of a coating prior to cure is not the same value after curing but there is a correlation. The powder comb is suitable as a guide only.
View more about Elcometer 155 Uncured Powder Film Comb on main site